Tiling
Cracked or drummy tiles: repair or replace?
One cracked tile or a hollow patch is often a local fix. Knowing what is causing it tells you whether to repair, replace or look further.
10 September 2026 · 4 min read
Tiling that sits flat, lines up and is finished properly
From a single replacement tile to a whole bathroom floor, we set tiles on a well-prepared surface and finish every edge so the result looks intended.
Good tiling is mostly preparation. A tile will only sit as flat as the surface under it, and it will only stay put if the adhesive has a sound, clean base to grip. That is where we spend the first part of every job.
We lay new floors and walls, replace tiles that have cracked or lifted, and patch damaged areas so the repair is hard to spot. If something about the surface worries us, we tell you before any tile goes down.
What this covers
Floor tiling
Kitchens, bathrooms, laundries, entries and outdoor areas, laid to a planned layout so cuts fall where they are least noticeable.
Wall and splashback tiling
Feature walls, shower walls and kitchen splashbacks, set plumb and level with even joints.
Replacing cracked or drummy tiles
We lift the failed tile, clean out the bed and set a new one flush with its neighbours.
Patch repairs
Where a section has been damaged by a leak, a removed fixture or plumbing work, we rebuild the gap and tile it back in.
How the job runs
- 1
Look at the surface
We check the floor or wall for movement, damp, level and old adhesive, and agree the layout with you.
- 2
Prepare the base
The surface is cleaned, patched and levelled so the tiles have something sound to bond to.
- 3
Set the tiles
Tiles are laid with the right adhesive for the surface and location, checked as we go for lippage and alignment.
- 4
Grout and finish
Once the adhesive has gone off we grout, then finish edges and junctions with flexible silicone where tiles meet other surfaces.
- 5
Clean and hand over
We clear the work area, wipe back any haze and walk you through aftercare and cure times.
Why do it this way
- Planned layouts that avoid thin slivers at doorways and walls
- A flat, even finish that is easy to clean
- Repairs matched as closely as the available tiles allow
- A clear written quote before any work starts
Tiling: common questions
Can you match my existing tiles?
We will always try. Where a range has been discontinued we look for the closest size, colour and finish, and we show you the options before anything is laid. A perfect match is not always possible with older tiles.
Do you supply the tiles?
Tell us what you would like in your enquiry and we will confirm in the quote what is supplied by you and what is supplied by us.
Can new tiles go over the old ones?
Sometimes. It depends on how well the old tiles are bonded, how flat they are and how much height the new layer adds at doors and fixtures. We check before recommending it.
How long before I can walk on a new floor?
Usually the next day for light foot traffic, but it depends on the adhesive and grout used. We give you the exact cure times for your job when we hand over.
What a job looks like
Often needed alongside tiling
Guides on this
Available across Northern Melbourne, South Eastern Melbourne, Eastern Melbourne, Western Melbourne and Melbourne CBD and inner city.
Get a quote for tiling
Send a few details and we will come back with a clear, written quote. There is no charge to ask.
- Servicing Melbourne, Victoria